All the Entry points are closed duly fitted with Plastic Curtains and windows are fitted with wire mesh.

Complete Capping of Aluminum Collapsible Tube is done in area where 10 microns filtered Air handling equipment is installed to develop positive pressure and Final packing is done in a Clean Room where three micron filter is installed meeting international standard with higher positive pressure then Capping area. Herein the tubes are subjected to blowing and suction cleaning and again blowing of Tubes is done and then thereafter entire tray is packed in polythene Bag and sealed.

To avoid contaminated with outer Carton and Paper dust both side laminated tray are use to pack tube and finally trays are packed in Poly Bag and sealed.

Special equipment is designed to clean the tubes vertically with open end at bottom by Air blowing and Vacuuming and again blown as it moves over the conveyor before final packing in clean room.

Packed material is transferred to newly created Finished Goods storing Area for Pre dispatch QC. And subsequent Dispatch.

A separate designated Area is allocated for raw Materials, Packing Materials, Finished Goods Rejection and Scrapped Materials and Q.C. Laboratory, Change Room and Lunch Room are away from manufacturing Area.

Manufacturing and storing areas are cleaned daily and Pest Control is carried out at regular interval and record of the same is maintained.

Bottle and Can Division :-
Well equipped with various capacities of impact extrusion presses, automatic neck forming machines, Can cutting Machines, Threading machines, Flanging Machines, Washing Plants with drying ovens etc.

Collapsible tubes Division :-
Well equipped with various capacities of impact extrusion presses, automatic tube finishing Machines, annealing ovens, internal lacquering machines with ovens, coating and printing lines with drying ovens, latex machines etc.

Tool room and development department :-
Well equipped with lathe machines, Cylindrical grinding machines, welding machines etc. to take care of all the tooling requirements, design and development of products and to take care of spares and maintenance requirements.

Q. A. Laboratorities:-
Well equipped with all equipments required for inspecting various parameters of aluminum bottles, collapsible tubes, cans and Pet bottles.

Utilities :-
Air compressor and generators to take care of total requirement of compressed air and power (incase of power failure from electricity board )